http://www.bax-u.com/wp-content/uploads/2013/01/Thin-as-Silk.jpg
Try this first and let us know. Here are the KEY differnce to avoid the neck area showing.
Wear your BAX-U brace like a shirt.
1- Loosen the shoulder straps and move them up on top of your shoulders. (keep it loose)
2- Pull as low as possible on the back “T” support almost 2-4cm= 1″-2″ below your neck line. (so it dosent show under a T-shirt/ shirt, the lower you pull down the more adjustablility you have on the shoulder area.)
3- Close the chest area.
4- Now the “Shoulder adjustablility”:
A- Open the velcor of right shoulder with right hand.
B- Bring your elbow on same level as your shoulder,
C- Look up
D- Roll your elbow in half circle motion towards the back,
E- Pull on the shoulder adjustable velcor hook (rough end) about (2-3cm= 1″-1.5″)
F- Place/ close/ stick on top of the shoulder velcor loop (soft area on shoulder).
G- Feel about 25-30% shoulder retraction. Dont go for a dramatic shift as the muscles will fatigue and it will not last long!
This correct wear will result in:
1- Keep the upper “V” away from your neck
2- Retract your shoulders
3- Allows yoru mid/lower back to act as a pivital point in moving you in better alighment and stronger muscles.
You should feel:
–Taller
–More straight
–Still have flexabilty of movment without slouching
You the above is in a video that you can find on the site [www.BAX-U.com]: Go to <strong>ORDER NOW </strong> scrol to bottom page, and watch how I run thru the above steps.
I hope this helps, Please write back to me at drg@BAX-U.com with an update.
Sincerely
Dr.G
from BAX-U Posture Corrector | Improve Posture | Better Shoulder Support http://www.bax-u.com/bax-u-fitting-am-i-wearing-it-right/